MozeGear The Tig28 Miniature Timecode Generator

MozeGear The Tig28 Miniature Timecode Generator

Saturday, February 2, 2008

2008 FEB ARRIVALS

Freedom Back™ Wireless Stereo In-Ear System is HERE!!
Freedom Back is a high quality UHF wireless stereo in-ear monitor system designed to replace loud, bulky and unsightly stage monitors while allowing the talent the freedom to move about the stage. It is a perfect companion to our highly successful
Hear Back personal monitor mixer system and the acclaimed Mix Back matrix monitor mixer.
The Freedom Back system includes a transmitter with antenna, wireless stereo receiver, carrying case, and rack mount kit with an extension cable for mounting the antenna on the front panel.



Freedom Back is available in UA and UB bands making it possible to utilize numerous units on a stage at one time. Band A operates from 584 – 608 MHz and band B operates from 655 – 679 MHz. With 120 channels per band, the user will be able to select frequencies that will not be subject to local TV station interference even after the impending FCC changes!
Transmitter Features:
120 digitally selectable UHF channels
Up to 10 transmitters may be used in the same space, depending on local UHF interference
Stereo or Mono switch on the rear of the transmitter
Back-lit LCD display of frequency, audio level, group and channel
XLR and 1/4 ” combo input connectors
Built-in automatic limiter
Stereo headphone or in-ear monitor jack with volume control
PAD switch attenuates signal by 12 dB
External whip antenna can be front mounted with included rack ears and extension cable
Receiver Features:
Wireless stereo belt pack allows freedom to move about the stage
Unlimited receivers may be used with one transmitter, when on the same frequency
Back-lit LCD displays frequency, group, channel, battery indicator, and Mono/Stereo
Stereo headphone or in-ear monitor jack with volume control
RF present LED
Batteries included















PR-35
  • Largest dynamic element in a hand held microphone

  • Wide frequency response

  • Articulate natural mid range

  • Best vocal microphone

  • Most versatile microphone

  • 3 position roll off switch

  • Rubberized coating

General Specifications
The PR 35 has been designed for commercial broadcast, recording and live sound reinforcement applications which require a smooth flat response over a wide frequency range. The PR 35 was designed around the acclaimed PR 30 element and incorporates a sorbothane shock mount to give the best possible results.

The PR 35 achieves its exceptional performance by using a special magnet structure and a large aluminum 1 1/2" low mass voice coil assembly. A carefully wound and placed hum bucking coil allows the PR 35 to be used close to video monitors without unwanted hum or buzz. Special attention has been paid to the phasing plug assembly with equally placed ports that sense audio from behind the source. It then enters them out of phase thus producing a very linear cardiod pattern.


This reduces the proximity effect while achieving the extreme articulation across its smooth 40 Hz- 18 kHz frequency response. The new Heil element can be used in extreme high sound pressure levels and is immune to overload conditions. It produces a beautifully smooth audio response without the inconvenience of phantom or outside d.c. powering.
The PR 35 is equipped with a three position roll off switch. The first position is flat, the second position rolls off at approximately -3 dB and the last position rolls off at approximately -6 dB.
The cardiod pattern offers the greatest rejection of unwanted audio at 180 degrees off axis, which is directly behind the microphone; there is virtually no off-axis coloration.
(Supplied with a microphone clip that mounts to any 5/8"- 27 mic thread.
It also comes with an aluminum carrying case.)